A traditional relay-and-fuse box doesn't scale. Every extra accessory on an EV, hybrid machine or off-highway platform means another relay, another fuse, another run of wire — until the harness itself becomes one of the heaviest, least reliable parts of the vehicle. A multiplexed power distribution module (MPDM) replaces that sprawl with a single, CAN-controlled unit, and at EMB Power, New Eagle's exclusive UK and EU partner for the Raptor toolchain, we specify and integrate them for automotive, marine, commercial vehicle and off-highway projects across the UK.
An MPDM is a network-controlled module that replaces a bank of discrete relays and fuses with software-configurable power channels. Instead of wiring a new relay and fuse every time a subsystem is added, an engineer allocates a channel on the module and switches it from the vehicle's control logic over CAN. The result is a smaller harness, fewer physical failure points, and power channels that can be reassigned or expanded by updating control logic rather than rewiring the vehicle.
Four practical advantages drive the shift, particularly on electrified and off-highway platforms where wiring weight, serviceability and diagnostics all matter more than on a conventional vehicle:
MPDMs earn their place in three recurring roles on the electrified and off-highway projects EMB Power supports:
Managing precharge sequencing, shutdown and service disconnects around a battery pack benefits from the deterministic, CAN-coordinated switching an MPDM provides, rather than standalone relays wired directly to a controller.
Lighting, pumps, fans, HVAC and infotainment typically draw from a mix of switched and unswitched supply paths. Consolidating these onto one module keeps the auxiliary wiring loom manageable as feature count grows.
Fleet and off-highway machines are frequently specified in multiple configurations from the same base platform. A software-addressable MPDM lets the same hardware support different accessory fit-outs without a different harness for every variant.
New Eagle's MPDM-NE1 is designed to sit alongside Raptor control modules on the same CAN network, with EMB Power supplying the matching connector kit — including a sealed power-input version for harsher environments — to get it wired in correctly the first time.1 Configuring channel assignment, sequencing and diagnostic reporting is done through the Raptor-Dev environment in MATLAB/Simulink, so switching logic for the MPDM lives in the same model as the rest of the controls project rather than in a separate tool. Once commissioned, Raptor-Cal allows channel behaviour to be tuned or recalibrated in the field without a new firmware build.
Is an MPDM the same thing as a body control module?
No. A body control module typically owns higher-level vehicle logic, while an MPDM is primarily a power-switching and distribution device; the two are often networked together, with the BCM commanding channels on the MPDM over CAN.
Can multiple MPDMs run on one vehicle network?
Yes. Because each module is individually addressable over CAN, larger or distributed architectures can use several MPDMs across different zones of the vehicle or machine rather than one oversized central unit.
Does switching to an MPDM require a different development toolchain?
Not if the rest of the project is already built on Raptor: channel configuration and diagnostics are handled within the same Raptor-Dev/Simulink environment used for the vehicle's other control functions.
Specifying an MPDM is only half the job — wiring, CAN configuration and diagnostics still need to be designed into the rest of the vehicle architecture correctly. As New Eagle's exclusive UK and EU partner for the Raptor and OpenECU toolchain, EMB Power supplies MPDM hardware alongside the engineering support to integrate it: channel planning, Raptor-Dev configuration, and validation against the rest of your control system. If you're specifying power distribution for an EV, marine, commercial vehicle or off-highway programme, get in touch with EMB Power for current pricing and a tailored recommendation.
1 Product and accessory availability per EMB Power's current online catalogue as of October 2026; confirm specification and lead times with EMB Power before finalising a design.